Xycd60 Manual Extra Quality (TOP-RATED)

Avoid running continuous loads right at the 10A limit to prevent the relay from overheating.

Always ensure the input voltage matches the battery's requirements. The module is a switch, not a buck/boost converter. xycd60 manual

The module supports TTL level UART communication (baud rate 9600), allowing you to read voltage and status or change settings via a computer or microcontroller. Avoid running continuous loads right at the 10A

This mode is used to protect batteries from deep discharge. The module connects the load when the battery is full and disconnects it once the voltage hits a minimum threshold. Voltage ≥is greater than or equal to UP . Condition to Stop: Voltage ≤is less than or equal to dn . Setting Up the XY-CD60 Entering Setup The module supports TTL level UART communication (baud

In this mode, the module connects the charger to the battery when the voltage drops below a set lower limit () and disconnects it when the battery reaches the upper limit ( UP ). Condition to Start: Voltage ≤is less than or equal to dn . Condition to Stop: Voltage ≥is greater than or equal to UP . 2. Discharging Mode (dn)

High-definition LCD screen showing voltage, percentage, and time. Modes: Charging Mode ( UP ) and Discharging Mode ( dn ). Operating Modes Explained 1. Charging Mode (UP)