Sinotimer Mc101 Manual 💫

Connect the positive and negative leads to the designated input terminals (check label for polarity).

0.3% measurement accuracy with a maximum resolution of 0.1°C for thermocouples and RTDs. sinotimer mc101 manual

Correct wiring is critical for safe operation. Always disconnect power before making connections. Refer to the specific diagram on your unit's label for the most accurate pinouts. Connect the positive and negative leads to the

Set "AT" to 1. The AT light on the panel will blink until the cycle is complete and the controller has calculated its PID constants. use the panel keys (SET

To customize the controller for your specific application, use the panel keys (SET, <, ∨, ∧). Press the SET key briefly. Use the < key to select the digit you want to change. Use the ∨ and ∧ keys to adjust the value. Press SET again to save the new target temperature. Switching Units (°C to °F):

Ensure the thermocouple type set in the software matches the physical sensor connected to avoid incorrect readings.