: To ensure a stable connection and high-speed data transfer, keep your ISP wires as short as possible (ideally under 10cm).
: The SM-M017F motherboard uses "pasted" eMMC (MCP) chips in some versions. Avoid excessive heat near the eMMC to prevent chip failure.
To establish a connection with tools like , UFI Box , or Medusa Pro , you must solder wires to these six primary points: DAT0 : Data line 0 for eMMC communication. CMD : Command signal line.
: If the device fails to boot after removing the ISP jumpers, ensure you haven't damaged the CLK resistor . In some cases, a small bridge or "jumper" over the CLK resistance point is needed to restore normal operation.
: Clock signal line (highly sensitive; requires short wires to avoid interference).
: Instead of soldering VCC and VCCQ, many technicians prefer to connect the phone via a USB cable to provide power, only soldering DAT0, CMD, CLK, and GND to the ISP box.
The (Galaxy M01s) ISP (In-System Programming) pinout is a critical hardware interface used by technicians to repair dead boots, bypass FRP (Factory Reset Protection), and perform eMMC-level data recovery. Unlike standard USB flashing, ISP involves soldering tiny "jumpers" directly to specific points on the motherboard to communicate with the internal storage. Key Pinout Connections for SM-M017F
: Accessing the storage directly when the screen or motherboard is damaged.
