Gt911 Register Map Site

This block is often sent as a complete "config array" during initialization. 3. Register Map

Defines screen resolution, touch thresholds, and sensor layout. Coordinate/Status Registers

This register is used to trigger specific device states. Common commands include: 0x00 : Read coordinate status. 0x05 : Enter to save power. 0x06/0x07 : Enter/Exit Charge mode for enhanced sensitivity. Configuration Registers (0x8047+) gt911 register map

Understanding this map is essential for developers writing custom drivers or troubleshooting touch response issues in embedded systems.

The register map is divided into three primary functional areas: Address Range Access Type Description Command Register Write Only Sends high-level commands like Sleep or Calibration. 0x8047 – 0x8100 Configuration Registers Read/Write This block is often sent as a complete

Depending on the state of the INT and RESET pins during power-on, the device uses either 0xBA/0xBB or 0x28/0x29 (8-bit write/read format).

The is the architectural blueprint used to interface with the Goodix GT911 capacitive touch controller. It defines how a host processor (like an STM32, Arduino, or Raspberry Pi) communicates via I2C to configure the touch panel, read coordinates, and manage power modes. Coordinate/Status Registers This register is used to trigger

Contains the touch point status and X/Y coordinates for up to 5 points. Command Register (0x8040)

The GT911 uses 16-bit register addresses. It supports auto-incrementing , allowing you to read or write a continuous block of data in a single I2C transaction. 2. Core Register Map Structure

The GT911 operates as an I2C slave. Before accessing the register map, you must establish the correct slave address.