Gemel Txshs User Manual Access

If you arm the alarm more than one minute after turning off the ignition, you must hold Button 1 for longer than one second. If the bike is left deactivated for over an hour, the system may shut down to save battery; in this case, cycle the ignition to wake it up. Deactivating the Motion Sensor

If you are transporting your bike on a trailer or train, you can disable the motion sensor while keeping the alarm armed: Arm the alarm by pressing . Press Button 1 again within the activation phase.

Turn the ignition OFF . Test the remote by arming and disarming the bike. Maintenance: Battery Replacement The Gemel TXSHS uses a CR 2032 3V lithium battery. Gemel Txshs User Manual

Hi all, As I mentioned in one of my previous posts I was going to change the two small batteries in my BMW alarm box (Gemel TXSHS) Gemel TXSHS alarm operating advice needed - UKGSer

Press both Button 1 and Button 2 simultaneously. Hold them for approximately 10 seconds until the LED on the remote stops flashing. If you arm the alarm more than one

Press to deactivate the system. The indicators will flash once to confirm. Synchronization Procedure

If the sync procedure fails, check the battery voltage. Low battery is the most common cause of pairing issues. Gemel TXSHS alarm operating advice needed - UKGSer Press Button 1 again within the activation phase

Insert the new battery, ensuring it does not touch other electrical components. The LED should light up once the battery is in place.

Ensure the remote is within the motorcycle's reception range. Turn the ignition key to the ON position.