Cisco+lab+162 Direct

Generate RSA keys with crypto key generate rsa (1024-bit modulus) and create a local user. Interface Configuration

Connect PCA to switch port F0/6 and PCB to F0/5.

Always use the no shutdown command to bring the interface up. Step 3: Verification Commands ITExamAnswershttps://itexamanswers.net 1.6.2 Lab - Configure Basic Router Settings (Answers) cisco+lab+162

Assign addresses to the router interfaces to enable routing between subnets: ip address [address] [mask] IPv6 Address: ipv6 address [address/prefix]

Connect switch port G0/1 to router port G0/0/1. Generate RSA keys with crypto key generate rsa

addressing on host devices and router interfaces.

This lab focuses on the initial setup and security of a Cisco router. By the end, you will be able to: By the end, you will be able to:

Once connected via a terminal emulator like Tera Term or PuTTY , follow these core configuration steps: Management and Security Identify the device with hostname R1 .